Firefly remote stopped working

[Thomas Rawley]

II installed the ATI Wonder 650 Tuner today. That installation was easy but then the Firefly remote stopped working after the install. It exhibited the same symptoms mentioned in previous posts. I uninstalled both the ATI Remote Wonder program ATI installed with the tuner and the Firefly application. Then I rebooted and installed the most up to date Firefly software which I downloaded from snapstream.com. Everything worked fine after the reinstallation!

Hope this helps someone.

Thomas

[Jim_C]

My original Firefly remote quit on about day 4. Tech support had me go thru a series of steps, most of which I had tried already (batteries, reinstall etc) then declared it dead. They sent me a new one once they received the original although they did not ask for the original packaging.

Remote 2 has worked fine.

Jim

[stereophrenic]

Originally Posted by graphicsgod

Check and see if the x10nets.exe is running under processes. I accidentally disabled it (in the services) and when I went to use the remote, it stoped working. Re enabling it got it working again.

Check this and see if that's the problem. Or if the x10nets.dll is corrupt.

Rob

This also fixed my problem. I just reenabled it, then re-ran the setup wizard.

[TimW]

I fried my receiver when I got up off the couch and touched the antenna. Zzzzzaaaaaaaapppppppp. Static shocked it, and it no longer responds. Must have blown out the antenna circuit, because it still registers in Windows, just won't receive anything. This is another possibility.

[Banger]

I was having the same problem went to control panel/system/device manager/hardware and found yellow ? updated the drivers and firefly remot started working again.