Setup Wizard crashes with Aver M780 analog channel setup

[Fast351]

Got my new AverMedia M780 dual tuner PCIe card in my HTPC. So now I have a pair of Fusion tuners and the new card. The digital section is fed from an antenna for OTA tuning (this section can also do QAM, but frankly I'm not that interested in QAM tuning). The analog section is hooked to my cable TV for tuning the extended basic package, roughly 80 analog channels.

The digital setup went without a hitch. I simply added a source, used an existing lineup, the OTA digitals already being used with the Fusion cards.

When I added the analog setup, I added a source, selected new lineup, selected the correct lineup for my ZIP code (Charter Extended Basic in case you're interested) and hit next to go to the testing setup page. The first time I tried it, I had it running on channel 2 for a bit and it worked. Then I tried tuning up to a different channel and the setup wizard crashed and just bailed out.

Thinking the channel change had caused the crash, I didn't try changing channels next time in the test setup, and it crashed right away, as soon as the channel dialed in. I tried it one more time, and the result was identical.

The final try I just started hitting the next button as soon as the test screen popped up, and it got through the testing page and set up the rest of the way.

It seems to work normally in the BTV interface. The channels tune, and it records just fine.

I'm concerned this may be a driver problem. Anyone else run into this?

-Mike

[Fast351]

Got my new AverMedia M780 dual tuner PCIe card in my HTPC. So now I have a pair of Fusion tuners and the new card. The digital section is fed from an antenna for OTA tuning (this section can also do QAM, but frankly I'm not that interested in QAM tuning). The analog section is hooked to my cable TV for tuning the extended basic package, roughly 80 analog channels.

The digital setup went without a hitch. I simply added a source, used an existing lineup, the OTA digitals already being used with the Fusion cards.

When I added the analog setup, I added a source, selected new lineup, selected the correct lineup for my ZIP code (Charter Extended Basic in case you're interested) and hit next to go to the testing setup page. The first time I tried it, I had it running on channel 2 for a bit and it worked. Then I tried tuning up to a different channel and the setup wizard crashed and just bailed out.

Thinking the channel change had caused the crash, I didn't try changing channels next time in the test setup, and it crashed right away, as soon as the channel dialed in. I tried it one more time, and the result was identical.

The final try I just started hitting the next button as soon as the test screen popped up, and it got through the testing page and set up the rest of the way.

It seems to work normally in the BTV interface. The channels tune, and it records just fine.

I'm concerned this may be a driver problem. Anyone else run into this?

-Mike

[Trilog]

Well thank you for the help. I'm having the same problem. but I am able to finish the setup now. I installed my Hauppauge 350 to be able to finish the setup before your information.(bad picture in comparison)









Asus a8n-vm csm / Athlon 64 4000 / OCZ Performance series 1GB (2 512) / Msi Geforce nx8500 GT(HDMI) / Avermedia M780 / Hauppauge 350